High-strength Easy to Ues 14 Cubi Cself Loading Concrete Mixer Pump
- Total supply:
The date of payment from buyers deliver within days
Browse the number:
high-strength easy to ues 14 cubi cself loading concrete mixer pump
Mobile concrete mixer, is a combination of concrete truck and concrete mixing station function as a whole, set the concrete load, measurement, mixing, out in one, and can achieve the concrete transport and on-site concrete construction operations mixing equipment, The equipment is fast and efficient, greatly improving the production efficiency and reduce the production time and cost. Applicable to all kinds of special environment, crowded urban areas and remote areas of concrete construction.
Mobile concrete mixer, including power absorption, mixing cylinder front and rear support, reducer, hydraulic system, mixing pipe, control mechanism, cleaning system. The working principle is through the coiling device to remove the power of the car chassis, driving the hydraulic system variable pump. The mechanical energy can be converted into the hydraulic energy of the motor. The motor drives the gear unit again and drives the stirrer through the gear unit. Stir.
Mobile Concrete Mixing Station Features:
1. Automatic feed mixer hydraulic system pressure should be in accordance with the instructions, can not be adjusted. Hydraulic oil and oil should meet the original requirements.
2. Move the mixer before loading, should row a row of residual water and debris. In the transport to keep spinning, to prevent concrete isolation. Before the mobile concrete mixing station reaches the site and unloads, the mixer should rotate at full speed for 14-18 revolutions per minute for 1-2 minutes and then reverse. The stirrer should stop turning before reversing.
Concrete mixer temperature is higher than 25 degrees Celsius, from charging, transport to discharge time of not more than 60 minutes; temperature below +25 degrees Celsius, the time should not exceed 90 minutes.
4. After the mixer is discharged, immediately rinse the hopper, discharge trough and so on. Back to the mixing station on the road, will be 150-200 liters of water into the blender, cleaning the cylinder wall and leaves combined with the concrete residue.
5. After moving the new mixer every day, the driver is responsible for injecting the injected water into the mixing tube, rotating at a high speed of 14-18 r / min for 5-10 minutes, and then draining to ensure that the pipe is clean. Use high-pressure water to clean the various parts of the mixing tank, should pay attention to avoid the instrument, joystick and other components. The distance between the pressure water nozzle and the body paint should not be less than 40 cm.
- Air Clean Equipment
- Cleaning Machine
- Environment Protection Device
- Filtration Equipment & Parts
- Guide Rail
- Mass Transfer and Separation Equipment
- Pneumatic Component
- Washing Equipment
- Ball Screw
- Cutter & Tongs
- Fastener & Fitting
- Industrial Adhesive Products
- Lean Pipe & Pipe Rack System
- Pipe & Tube System
- Sealing & Gaskets
- Universal Hardware Parts